Confidential
Appendix Protection for Transportation 84
M200 / M205 / M100 / M105 Series
Revision A
5.3.2 Securing the Paper Support/Paper Support Sub
Purpose
To prevent damaging the Paper Support/Paper Support Sub by the shock during transportation.
Risks if it is not performed
The Paper Support/Paper Support Sub will be scratched and the abrasion powder will be produced due to the
shock during transportation.
Preparation
Prepare two pieces of strong tape
Multifunction Printer
• 1) Length: 60 mm, width: 22 mm, fold one end 5 ± 2 mm.
• 2) Length: 50 mm, width: 22 mm, fold one end 5 ± 2 mm.
Singlefunction Printer (3 tapes)
• Length: 80 mm, width: 16 mm, fold one end 5 ± 2 mm.
Method
Multifunction Printer
1. Attach the strong tape 1) to the position on the following diagram A and secure the Paper Support Sub.
2. Attach the strong tape 2) to the position on the following diagram B and secure the Paper Support.
Figure 5-3. Securing the Paper Support/Paper Support Sub (Multifunction Printer)
Diagram B
Paper Support Sub
Folded ends
Diagram A
Folded ends
Paper Support
Housing Left
Strong tape
To Next Page
Loading...
