10
Wearing the Controller
This section explains how to wear the controller on your arm using
the armband.
A
Placing the controller in the controller holder.
Place it in the holder so that the control panel of the controller
is visible.
B
Run the armband through the controller holder, and
create a loop the thickness of your arm.
Note
The armband can also be threaded vertically.
C
Place the controller holder on your arm and secure
it with the armband.
D
Wind up the extra cable, and secure it in place with
the strap.
Make sure the cable does not catch on anything in the sur-
rounding area.
E
Secure the cable with the reel clip.
Secure the reel clip to your collar.
Wearing the Controller on Your Arm
C
Adjust the length of the belt.
Adjust the length so that the controller is in a position where it
can be operated comfortably.
D
Secure the cable with the reel clip.
Attach the reel clip to the belt of the shoulder holder, and
route the cable behind your back.
You can use the optional shoulder holder to wear the controller
on your chest.
Note
• Make sure you use the snap fastener on the accessory case to pre-
vent the product from falling.
• You can also attach a headlight to the shoulder holder.
A
Placing the controller in the controller holder.
Place it in the holder so that the control panel of the controller
is visible.
B
Adjust the shoulder holder so that the controller is
at the front, and then fasten the adjuster.
Wear the shoulder holder so that the control panel of the
controller is at the front.
Wearing the Shoulder Holder
BT-2200 BT-2000
For Both Headsets
To Next Page
Loading...