8
Turning O
Hold down the [ ] power button for more than one second, and
then select [OK] in the message displayed by the headset.
Note
If operations freeze, you can force the product to shutdown by using
one of the following methods.
• Hold on the [
] power button for more than eight seconds.
• Use something thin to press the reset button for at least two sec-
onds.
Caution
Do not force the product to shutdown unless operations freeze. Stored
data and settings may be lost.
Turning On
Press the [ ] power button until the power indicator is lit light
blue.
The power indicator flashes light blue when starting up. Startup is
complete when the power indicator changes from flashing to turn
light blue.
When you turn on the product, images are displayed approximately
4 m away from you when viewed through the lens.
4m
Note
How an image is perceived varies depending on the individual.
Turning off the screen while the product is on (Sleep
mode)
When you press the [ ] power button briefly, the power indicator
turns blue, and the product enters sleep mode. Press the [
] pow-
er button briefly again to wake the product from sleep mode.
Disabling controller operations (Key lock)
When you hold down the [ ] key lock button, the key lock indi-
cator is lit blue, and the key lock turns on. Press the [
] key lock
button again to release the key lock.
Turning On and O
Note
Before turning on the product, check that the battery is charged.
➡
“Charging the Battery” p. 6
BT-2200 BT-2000
For Both Headsets
For Both Headsets
To Next Page
Loading...