12
Part Names and Functions
A
Camera
Captures images and movies. Remove the protective film before
use. You can adjust the angle of the camera.
B
Camera indicator
Flashes while the camera is operating.
C
Light sensor
Senses the brightness of your surroundings and automatically
adjusts the brightness of the screen.
D
Head pad
Fits against your forehead when wearing the headset. The head
pad is equipped with a built-in sensor to detect the position
and direction of the product.
E
Lens
Displays images. When not displaying images, you can slide up
the lens to the head pad.
F
Lens justier
You can adjust the position of the lens vertically. Adjust the
left and right by the same amount so that the lens is not tilted
during adjustment.
G
Rubber band
Secures the headset to your helmet.
➡
“Replacing the Rubber Band (BT-2200)” p. 14
H
Helmet holder
Use the four helmet holders to make sure the headset does not
come off during use.
This also secures cables when wearing the headset.
I
Adjuster
Adjusts the length of the rubber band according to the size of
the helmet.
J
Band holder
Route the band through each of these when replacing the
rubber band.
K
Inner pad
Sticks to the front of the helmet.
L
Screw holes to secure the shade/protective shield/
lens holder
Install the shade/protective shield using the exterior screw
holes. Install the lens holder using the interior screw holes.
➡
“Installing the Shade/Protective Shield/Lens Holder”
p. 7
Headset (BT-2200)
BT-2000
For Both Headsets
BT-2200
To Next Page
Loading...