16
Part Names and Functions
Headset (BT-2000)
A
Camera
Captures images and movies. Remove the protective film before
use. You can adjust the angle of the camera.
B
Camera indicator
Flashes while the camera is operating.
C
Light sensor
Senses the brightness of your surroundings and automatically
adjusts the brightness of the screen.
D
Head pad
Fits against your forehead when wearing the headset. The head
pad is equipped with a built-in sensor to detect the position
and direction of the product.
E
Lens
Displays images. When not displaying images, you can slide up
the lens to the head pad.
F
Lens justier
You can adjust the position of the lens vertically. Adjust the
left and right by the same amount so that the lens is not tilted
during adjustment.
G
Head band
Secures the headset on to your head. You can adjust the length
to fit the size of your head (head circumference: 560 to 640
mm).
H
Cable securer
Secures cables when wearing the headset.
I
Screw holes to secure the shade/protective shield/
lens holder
Install the shade/protective shield using the exterior screw
holes. Install the lens holder using the interior screw holes.
➡
“Installing the Shade/Protective Shield/Lens Holder”
p. 7
J
Inner pad (B)
If the headset feels tight, replace this with the inner pad A or C.
Using a smaller inner pad loosens the headset.
➡
“Replacing the Inner Pad” p. 7
For Both Headsets
BT-2200 BT-2000BT-2000
To Next Page
Loading...