Epson Perfection 1670 Photo - Disassembly Procedure

EPSON Perfection 1670 Photo/Perfection 1270 Revision B
DISASSEMBLY/ASSEMBLY Disassembly Procedure 14
2.2 Disassembly Procedure
This section illustrates how to remove the main components of this product. Unless otherwise specified, the reassembly procedure is omitted here since the product can be reassembled
in the reverse order of the disassembly procedure. For the engagement of the main components, refer to the general exploded views in the Appendix.
The following flowchart shows the disassembling procedure step-by-step. When disassembling any unit, refer to the corresponding page number shown in the following figure.
Figure 2-2. Disassembly/Reassembly Flowchart
Start
Removal of TPU Unit
(P.15)
Removal of Upper Housing
(P.16)
Removal of Carriage Unit
(P.19)
Removal of CR Motor
(P.23)
Removal of I/F Board
(P.18)
Removal of Panel Board
(P.24)
Removal of Pulley Set and
Pressure Spring (P.25)
Removal of TPU Inverter Board
(P.26)
Removal of Hinge Holders
(P.28)