Epson Perfection 1670 Photo - Page 21

EPSON Perfection 1670 Photo/Perfection 1270 Revision B
DISASSEMBLY/ASSEMBLY Disassembly Procedure 21
8. Peel the Carriage FFC, which is secured by a double-faced tape, from the FFC Stop
Plate.
9. Using the flat-blade screwdriver, hold down the Pulley Set Stop Plate and decrease the
tension of the Timing Belt, and remove the Timing Belt from the Pulley Set.
10. Remove the Timing Belt from the Carriage Unit.
Figure 2-16. Adhesion of Carriage FFC
Figure 2-17. Removal of Timing Belt
Adhere the Carriage FFC to the FFC Stop Plate in the position shown
in Figure 2-16.
C A U T I O N
When removing the Timing Belt, fully be careful since the Pressure
Spring may pop out and be lost.
Adhering position
FFC Stop Plate
Pulley Set
Step 9-1)
Step 9-2)
Step 10
Timing Belt
Pulley Set Stop Plate