EasyManuals Logo

Epson PictureMate Setup

Epson PictureMate
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
1. Press the On button to turn on the printer.
2. Shake the new photo cartridge four or five times.
3. Remove the photo cartridge from its protective bag.
4. Open the cover on the back of the printer. Slide the lever into the
Release position by sliding it in the direction shown.
5. Place the cartridge properly into the cartridge holder, then push
it in until you feel resistance and hear the cartridge faintly click
into place.
Note:
After installing the cartridge, make sure the sides of the cartridge are even. If
either side of the cartridge sticks out, push the side of the cartridge until it clicks.
6. Set the lever to the Lock position by sliding it in the direction shown.
Close the cover.
c
Caution:
Do not load paper until ink charging is complete.
Note:
If you cannot close the cover, the photo cartridge is not installed correctly. Go
back to Step 4 and eject the photo cartridge. Then install the photo cartridge
again
7. The printer automatically starts to charge ink. Charging takes
about three minutes.
c
Caution:
Do not turn off the printer during the ink charging process.
8. Press the OK button to finish.
Note:
The photo cartridge packaged with your printer is partly used during initial setup.
In order to produce high quality printouts, the print head in your printer will be
fully charged with ink. This one-off process consumes a quantity of ink and
subsequent cartridge will last for their full rated life.
Do not touch this part.
c
Caution:
Do not shake the photo cartridge after
removing it from the bag; it can cause
leakage.
Do not remove or tear the label on the
cartridge; this can cause leakage.
Setup
c
Cautions must be observed to
avoid damage to your
equipment.
Notes contain important information
and useful tips on the operation of
your printer.
Cautions and Notes
Continue to the next page...
Connect the power cord and AC adapter, then plug-
in the printer.
2 Getting Started1 Unpacking
Photo Printer
Remove the contents from the box. Remove all tape from the printer.
printer
photo cartridge
The contents may vary in certain locations.
Setup
Direct Print
Guide
CD-ROM PictureMate
Photo Paper
Software
Installation
Guide
AC adapter power cord
3 Installing the Photo Cartridge
Copyright© 2005 Seiko Epson Corporation. All rights reserved.
Printed in XXXXXX XX.XX-XX XXX

Other manuals for Epson PictureMate

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson PictureMate and is the answer not in the manual?

Epson PictureMate Specifications

General IconGeneral
Print technologyInkjet
Maximum resolution5760 x 1440 DPI
Time to first page (color, normal)114 s
Maximum input capacity20 sheets
Mac compatibilityYes
Dimensions (WxDxH)256 x 154 x 163 mm
Connectivity technologyWireless
Power consumption (printing)13.5 W
Operating temperature (T-T)10 - 35 °C
Printing sizes10 x 15 cm
Minimum RAM128 MB
Minimum storage drive space150 MB
Sound pressure level (printing)42 dB
Country of originHong Kong
Market positioningHome & office
Pallet width800 mm
Pallet height1770 mm
Pallet length1200 mm
Pallet width (UK)1000 mm
Quantity per pallet72 pc(s)
Quantity per pallet (UK)108 pc(s)
Quantity per pallet layer24 pc(s)
Quantity per pallet layer (UK)36 pc(s)
Package depth325 mm
Package width395 mm
Package height275 mm
Package weight4594 g
Quantity per pack1 pc(s)

Related product manuals