Maintaining the Projector 65
Cleaning the Air Filter and Vent
Clean the air filter and air intake vent after every 100 hours of use. If
they are not cleaned periodically, they can become clogged with dust,
preventing proper ventilation. This can cause overheating and damage
the projector.
Follow these steps:
1. Turn off the projector and unplug the power cord.
2. Turn the projector upside down.
3. To clean the intake vent and filter, use a small vacuum cleaner
designed for computers and other office equipment. If you don’t
have one, gently clean the vent with a soft brush (such as an
artist’s paintbrush).
4. If the dirt is difficult to remove or the filter is broken, replace the
filter as described on page 68. Contact your dealer or call Epson at
800-GO-EPSON (800-463-7766) to obtain a new filter.
note
To order replacement air
filters, request part number
V13H134A08. See page 11
for ordering information.
To Next Page
Loading...
