EasyManuals Logo

Epson PowerLite S11 User Manual

Epson PowerLite S11
179 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
2. Connect the power cord to the projector's power inlet.
3. Plug the power cord into an electrical outlet.
The projector's power light turns orange. This indicates that the projector is receiving power, but is
not yet turned on (it is in standby mode).
Note: With Direct Power On turned on, the projector turns on as soon as you plug it in.
4. Press the power button on the projector or the remote control to turn on the projector.
The projector beeps and the power light flashes green as the projector warms up. After about five
seconds, the power light stops flashing and turns green.
Warning: Never look into the projector lens when the lamp is on. This can damage your eyes and is
especially dangerous for children.
If you do not see a projected image right away, try the following:
Turn on the connected computer or video device.
Insert a DVD or other video media, and press the play button (if necessary).
46

Table of Contents

Other manuals for Epson PowerLite S11

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson PowerLite S11 and is the answer not in the manual?

Epson PowerLite S11 Specifications

General IconGeneral
Matrix type3-panel (p-Si TFT active)
Projection distance- m
Projection technologyLCD
Contrast ratio (typical)3000:1
Screen size compatibility30 - 350 \
Projector native resolutionSVGA (800x600)
Keystone correction, horizontal30 °
InterfaceUSB
Aspect ratio4:3
RS-232 ports1
Dimensions (WxDxH)295 x 79 x 229 mm
Connectivity technologyWired
FocusManual
Zoom capabilityYes
Focal length range16.7 mm
Lamp typeUHE
Lamp power200 W
Lamps quantity1 lamp(s)
Light source typeLamp
Service life of light source4000 h
Service life of light source (economic mode)5000 h
DVI portNo
HDMI ports quantity0
Serial interface typeRS-232
USB 2.0 ports quantity2
Analog signal format systemNTSC, NTSC 4.43, PAL, PAL 60, PAL M, PAL N, SECAM
Supported graphics resolutions1280 x 960, 1024 x 768 (XGA), 1152 x 864 (XGA+), 1280 x 1024 (SXGA), 1280 x 768 (WXGA), 1280 x 800 (WXGA), 1360 x 768 (WXGA), 1400 x 1050 (SXGA+), 1440 x 900 (WXGA+), 640 x 480 (VGA), 800 x 600 (SVGA)
RMS rated power2 W
Product colorWhite
Cable lock slot typeKensington
AC input voltage100 - 240 V
AC input frequency50 - 60 Hz
Power consumption (standby)2.9 W
Power consumption (typical)283 W
Noise level37 dB
Noise level (economic mode)29 dB
Storage temperature (T-T)5 - 35 °C
Weight and Dimensions IconWeight and Dimensions
Weight2300 g

Related product manuals