EasyManuals Logo

Epson PowerLite S11 User Manual

Epson PowerLite S11
179 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #97 background imageLoading...
Page #97 background image
2. Gently remove the dust using a small vacuum designed for computers or a very soft brush (such as
a paintbrush).
Note: You can remove the air filter so you can clean both sides of it. Do not rinse the air filter in
water, or use any detergent or solvent to clean it.
Caution: Do not use canned air, or the gases may leave a residue.
3. If dust is difficult to remove or the air filter is damaged, replace the air filter.
Parent topic: Air Filter and Vent Maintenance
Replacing the Air Filter
You need to replace the air filter in the following situations:
After cleaning the air filter, you see a message telling you to clean or replace it
The air filter is torn or damaged
You can replace the air filter while the projector is mounted to the ceiling, if necessary. The illustrations
here show the projector placed on a table.
1. Turn off the projector and unplug the power cord.
97

Table of Contents

Other manuals for Epson PowerLite S11

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson PowerLite S11 and is the answer not in the manual?

Epson PowerLite S11 Specifications

General IconGeneral
Matrix type3-panel (p-Si TFT active)
Projection distance- m
Projection technologyLCD
Contrast ratio (typical)3000:1
Screen size compatibility30 - 350 \
Projector native resolutionSVGA (800x600)
Keystone correction, horizontal30 °
InterfaceUSB
Aspect ratio4:3
RS-232 ports1
Dimensions (WxDxH)295 x 79 x 229 mm
Connectivity technologyWired
FocusManual
Zoom capabilityYes
Focal length range16.7 mm
Lamp typeUHE
Lamp power200 W
Lamps quantity1 lamp(s)
Light source typeLamp
Service life of light source4000 h
Service life of light source (economic mode)5000 h
DVI portNo
HDMI ports quantity0
Serial interface typeRS-232
USB 2.0 ports quantity2
Analog signal format systemNTSC, NTSC 4.43, PAL, PAL 60, PAL M, PAL N, SECAM
Supported graphics resolutions1280 x 960, 1024 x 768 (XGA), 1152 x 864 (XGA+), 1280 x 1024 (SXGA), 1280 x 768 (WXGA), 1280 x 800 (WXGA), 1360 x 768 (WXGA), 1400 x 1050 (SXGA+), 1440 x 900 (WXGA+), 640 x 480 (VGA), 800 x 600 (SVGA)
RMS rated power2 W
Product colorWhite
Cable lock slot typeKensington
AC input voltage100 - 240 V
AC input frequency50 - 60 Hz
Power consumption (standby)2.9 W
Power consumption (typical)283 W
Noise level37 dB
Noise level (economic mode)29 dB
Storage temperature (T-T)5 - 35 °C
Weight and Dimensions IconWeight and Dimensions
Weight2300 g

Related product manuals