Epson PowerLite S11 User Manual

1. Hold down the Freeze button on the remote control until you see the Password Protect menu. This
takes about five seconds.
2. Press the down arrow to select Password and press Enter.
You see the prompt "Change the password?".
3. Select Yes and press Enter.
4. Hold down the Num button on the remote control and use the numeric buttons to set a four-digit
password.
The password displays as **** as you enter it. Then you see the confirmation prompt.
5. Enter the password again.
You see the message "Password accepted."
6. Press Esc to return to the Password Protect menu.
7. Make a note of the password and keep it in a safe place in case you forget it.
75

Epson PowerLite S11 Specifications

General

Matrix type	3-panel (p-Si TFT active)
Projection distance	- m
Projection technology	LCD
Contrast ratio (typical)	3000:1
Screen size compatibility	30 - 350 \
Projector native resolution	SVGA (800x600)
Keystone correction, horizontal	30 °
Interface	USB
Aspect ratio	4:3
RS-232 ports	1
Dimensions (WxDxH)	295 x 79 x 229 mm
Connectivity technology	Wired
Focus	Manual
Zoom capability	Yes
Focal length range	16.7 mm
Lamp type	UHE
Lamp power	200 W
Lamps quantity	1 lamp(s)
Light source type	Lamp
Service life of light source	4000 h
Service life of light source (economic mode)	5000 h
DVI port	No
HDMI ports quantity	0
Serial interface type	RS-232
USB 2.0 ports quantity	2
Analog signal format system	NTSC, NTSC 4.43, PAL, PAL 60, PAL M, PAL N, SECAM
Supported graphics resolutions	1280 x 960, 1024 x 768 (XGA), 1152 x 864 (XGA+), 1280 x 1024 (SXGA), 1280 x 768 (WXGA), 1280 x 800 (WXGA), 1360 x 768 (WXGA), 1400 x 1050 (SXGA+), 1440 x 900 (WXGA+), 640 x 480 (VGA), 800 x 600 (SVGA)
RMS rated power	2 W
Product color	White
Cable lock slot type	Kensington
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	2.9 W
Power consumption (typical)	283 W
Noise level	37 dB
Noise level (economic mode)	29 dB
Storage temperature (T-T)	5 - 35 °C

Weight and Dimensions

Weight	2300 g