EasyManuals Logo

Epson PowerLite S27 User Manual

Epson PowerLite S27
242 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #192 background imageLoading...
Page #192 background image
Important Safety Instructions
Follow these safety instructions when setting up and using the projector:
Do not look into the lens when the projector is on. The bright light can damage your eyes. Avoid
standing in front of the projector so the bright light does not shine into your eyes.
Do not place the projector on an unstable cart, stand, or table.
Do not operate the projector on its side, or while tilted to one side. Do not tilt the projector more than
12° forward or back.
If the projector is mounted on a ceiling or wall, it should be installed by qualified technicians using
mounting hardware designed for use with this projector.
When installing or adjusting a ceiling or wall mount, do not use adhesives to prevent the screws from
loosening and do not use oils or lubricants. This may cause the projector case to crack and the
projector to fall from its ceiling mount. This could cause serious injury to anyone under the mount and
could damage the projector.
Do not use the projector near water, sources of heat, high-voltage electrical wires, or sources of
magnetic fields.
Use the type of power source indicated on the projector. Use of a different power source may result in
fire or electric shock. If you are not sure of the power available, consult your dealer or power company.
Place the projector near a wall outlet where the plug can be easily unplugged.
Take the following precautions when handling the plug: Do not hold the plug with wet hands. Do not
insert the plug into a dusty outlet. Insert the plug firmly into the outlet. Do not pull the power cord when
disconnecting the plug; always be sure to hold the plug when disconnecting it. Do not overload wall
outlets, extension cords, or power strips. Failure to comply with these precautions could result in fire or
electric shock.
Do not place the projector where the cord can be walked on. This may result in fraying or damage to
the plug.
Unplug the projector from the wall outlet before cleaning. Use a dry cloth (or, for stubborn dirt or
stains, a moist cloth that has been wrung dry) for cleaning. Do not use liquid or aerosol cleaners, any
sprays containing flammable gas, or solvents such as alcohol, paint thinner, or benzine.
Do not block the slots and openings in the projector case. They provide ventilation and prevent the
projector from overheating. Do not operate the projector on a sofa, rug, or other soft surface, or set it
on top of loose papers. Do not cover the projector with a blanket, curtain, or tablecloth. If you are
setting up the projector near a wall, leave at least 7.9 inches (20 cm) of space between the wall and
the air exhaust vent.
Do not operate the projector in a closed-in cabinet unless proper ventilation is provided.
192

Table of Contents

Other manuals for Epson PowerLite S27

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson PowerLite S27 and is the answer not in the manual?

Epson PowerLite S27 Specifications

General IconGeneral
Matrix size0.55 \
Matrix type3-panel (p-Si TFT active)
Number of colors1.073 billion colors
Native aspect ratio4:3
Projection distance1.77 - 2.4 m
Projection technology3LCD
Contrast ratio (typical)10000:1
Screen size compatibility30 - 350 \
Projection distance (tele)0 - 2.4 m
Projection distance (wide)0 - 1.77 m
Projector native resolutionSVGA (800x600)
Keystone correction, horizontal-30 - 30 °
Projector brightness (economic mode)1890 ANSI lumens
FocusManual
Throw ratio1.45 - 1.96:1
Focal length range16.9 - 20.28 mm
Aperture range (F-F)1.44 - 1.44
Lamp typeUHE
Lamp power200 W
Lamps quantity1 lamp(s)
Light source typeLamp
Service life of light source5000 h
Service life of light source (economic mode)10000 h
Full HDNo
Video processing10 bit
Analog signal format systemNTSC, NTSC 4.43, PAL, PAL 60, PAL M, PAL N, SECAM
Supported graphics resolutions1280 x 800, 1366 x 768, 1024 x 768 (XGA), 1280 x 1024 (SXGA), 1400 x 1050 (SXGA+), 1440 x 900 (WXGA+), 640 x 480 (VGA)
DC-in jackYes
USB connector typeUSB Type-A, USB Type-B
Serial interface typeRS-232
USB 2.0 ports quantity2
Ethernet LAN (RJ-45) ports-
Noise level37 dB
2D/3D frequency image50 - 85 Hz
Noise level (economic mode)29 dB
RMS rated power5 W
PlacementDesktop, Ceiling
Product typeStandard throw projector
Product colorWhite
Cable lock slot typeKensington
Power sourceAC
AC input voltage100 - 240 V
Voltage tolerance10 %
AC input frequency50 - 60 Hz
Power consumption (standby)0.21 W
Power consumption (typical)284 W
Power consumption (economy mode)208 W
Storage temperature (T-T)-10 - 60 °C
Operating temperature (T-T)5 - 35 °C
Storage relative humidity (H-H)10 - 90 %
Operating relative humidity (H-H)20 - 80 %
Sustainability certificatesRoHS
Weight and Dimensions IconWeight and Dimensions
Depth244 mm
Width297 mm
Height87 mm
Weight2500 g

Related product manuals