101
Maintaining and Transporting the Printer | 101
You see a screen like the following:
3. Click the
Nozzle Check icon.
4. Click
Print to print the nozzle check pattern.
5. Examine the nozzle check pattern to make sure it has no gaps or lines.
• If the printout looks okay as shown below, you’re done. Click
Finish.
• If you see any gaps as shown below, click Clean to clean the print
head and follow the on-screen instructions.
6. If the nozzles do not clear after a few cleaning cycles, run a Power
Cleaning Cycle, as described in the next section.
To Next Page
Loading...
