11
Note: If you must start a workout before GPS location is complete, press the Start/Stop button.
Your watch continues locating and begins measuring your workout with the built-in stride sensor.
The watch will not record some measurements that require GPS signals, such as your workout
route, until GPS location is complete.
3. Press the Start/Stop button to start workout measurement.
If your watch displays the Locating GPS Failed message, GPS location has failed:
Move to an outdoor area with no overhead obstructions and press the Back button to try again.
Parent topic: Measuring Workouts
Stopping Workout Measurement and Saving the Data
You can save up to 248 sessions of workout data.
Note: You can save up to 99 hours for each lap. If you exceed this time, workout measurement stops.
1. At the Measurement screen, press the Start/Stop button to pause workout measurement.
To Next Page
Loading...
