Uploading Measurement
Data
Upload measurement data to the web application
(RUNSENSE View.)
Take the following two steps to upload data via a
smartphone.
Uploading basic data
Upload data such as the distance, speed, HR, and
calories.
Uploading detailed data
Upload the running route in addition to the outline
data.
c
Important:
❏ You need to log in to RUNSENSE View and
register this product to the smartphone.
U “Preparation” on page 6
❏ Enable Bluetooth on the smartphone before
uploading measurement data.
U “Enabling Bluetooth on your
smartphone” on page 11
Note:
It is recommended to upload the data via a personal
computer by setting this device in the cradle when
uploading data worth several hours such as
measurement data of a full marathon (uploading 4-hour
worth data with smartphone takes roughly 12 minutes.*)
Refer to "Data Management Using the Web Application
(RUNSENSE View)" in the "User Manual" for how to
upload data via a personal computer.
*The uploading time varies depending on the
smartphone you are using.
A
Start Run Connect on your
smartphone.
B
Tap Watch Data.
C
Hold down D on this product.
Bluetooth communication starts.
Smartphone User's Guide
Uploading and Checking Measurement Data
15
To Next Page
Loading...
