Epson SOLAR Series - Operation-01; Crown and Button Operation; Zero Position and System Reset

Date :
0 click 1st click
Crown Free
Turn clockwise for date
change
2H button
Chronograph Start/Stop
Restart
Chronograph Start/Stop
Restart
4H button
Chronograph Reset
Split
Split release
Chronograph Reset
Split
Split release
[*1] How to set the "0" position / System-reset (Crown position : 2nd click)
How to set the "0" position.
Pull crown out to the 2nd click position.
↓
Press 2H button for 2 seconds.
↓
Press 4H button repeatedly to set it to "0" position.
↓
Press 2H button for 2 seconds.
↓
Press 4H button repeatedly to set it to "0" position.
↓
Push crown back to normal position.
System-reset
Pull crown out to the 2nd click position.
↓
Press 2H and 4H buttons at the same time for longer than 2 seconds.
It is necessary to set the "0" position after system-reset.
Press 2H button for 2 seconds here will allow you to resume the procedure again as
indicated by the arrow if necessary.
Minute chronograph hand turns a full round and can now be
set to correct "0" position.
1/5 second chronograph hand turns a full round and can now
be set to correct "0" position.
[*1]
2nd click
Time setting
[*1]
Crown position
Cal.
Operation-01
24/Apr./'15
Rev. : 01
VS75A
0 ® 1 ® 2
2H button
4H button
Minute hand
1/5 second chronograph hand
Minute chronograph hand
Crown
Hour hand
Small second hand
24 hour hand
P.10-01