Connecting the Printer to the Network
How you connect the printer to the network depends on your
network type:
❑ If you are connecting to an Ethernet network using a thin
coaxial (10BASE2) cable, first attach the T-connector
supplied with the board to the 10BASE2 connector on the
Ethernet interface board. Connect the network cable to one
node of the T-connector.
If the printer is not the last device in a daisy-chain, connect
another network cable to the other node of the T-connector.
If the printer is the last device, attach a 50-ohm terminator
to the other node of the T-connector.
❑ If you are connecting to an Ethernet network using a
twisted-pair (10BASE-T) cable, connect the network cable’s
RJ-45 connector to the 10BASE-T connector on the Ethernet
interface board.
Using Optional Interfaces
A-5
To Next Page
Loading...
