5-124
124 | Maintaining and Transporting the Printer
Preparing the Printer for Shipment
1. Turn the printer on and remove the following parts:
• All paper or other media
• Roll paper spindle
• Paper tray
2. If you are using the 110 ml ink cartridges, leave them installed. If you
are using 220 ml cartridges, remove them and install 110 ml cartridges.
To store partially used cartridges removed from the printer, tape over
the needle valve hole and place each cartridge in a separate, resealable
plastic bag. Be sure to remove the tape before reinstalling the cartridges.
The printer must be powered on when removing or installing ink
cartridges.
3. Raise the ink levers.
Caution: To avoid spilling
ink and damaging the
printer, you must leave
the cartridges in place,
raise the ink levers, and
lock the print head.
sp4800Guide.book Page 124 Tuesday, March 7, 2006 3:49 PM
To Next Page
Loading...
