4
5.
The following Found New Hardware Wizard screen for IEEE 1394 status will be displayed. Select Install the software
automatically (Recommended) option selected and click on Next to continue. After the driver files have been copied to you
local hard disk drive, click on Finish to complete the driver installation.
6. After the IEEE 1394 driver installation is completed on the following Found New Hardware Wizard screen select, Install
the software automatically (Recommended) option then click on Next to start the printer driver installation. Next, you will
see the progress bar followed by the Windows Logo verification screen. Click on Continue Anyway option to continue.
7.
After the driver files have been copied to you local hard disk drive, click on Finish to compete the driver installation.
8. To install Epson Status Monitor 3 follow the instructions under section heading Installation Procedure for Epson Status
Monitor 3
.
To Next Page
Loading...
