Epson Stylus CX3800 Series
6/05 Epson Stylus CX3800 Series - 3
Scanning
Scanner type Flatbed color image scanner
Photoelectric device Color CIS line sensor
Effective pixels 5,100 × 14,040 pixels at 600 dpi,
100%
Document size Letter (8.5 × 11.0 inches) or A4
(8.5 × 11.7 inches); reading area is
selectable with software
Scanning resolution 600 dpi (main), 1200 dpi (sub)
Output resolution 50 to 2400, 7200, and 9600 dpi
(50 to 2400 dpi in 1 dpi increments)
Color separation RGB color filters on CCD
Image data 16 bits per pixel per color internal
1 to 8 bits per pixel per color external
Gamma correction User defined 2 level
Light source RGB Three Color LED
Interface USB 2.0 compatible
Mechanical
Paper feed method Friction
Paper path Sheet feeder, top feed
Sheet feeder
capacity Approx. 100 sheets at 17 lb (64 g/m
2
)
Dimensions 16.9 × 13.5 × 6.7 inches (W × D × H)
430 × 344 × 170 mm (W × D × H)
Weight Approx. 25.8 lb (11.7 kg) without the
ink cartridges
Electrical
Input voltage range* 90 to 132 V
Rated frequency
range 50 to 60 Hz
Rated current 0.4 A (Max 0.7 A)
Power consumption Approx. 10 W (ISO 10561 Letter
Pattern)
Approx. 3 W in sleep mode
Approx. 0.2 W in power-off mode
* Check the label on the back of this product for voltage information.
Environmental
Temperature
Operation 50 to 95 °F (10 to 35 °C)
Storage* – 4 to 104 °F (– 20 to 40 °C)
1 month at 104 °F (40 °C)
Humidity (without condensation)
Operation 20 to 80% RH
Storage* 5 to 85% RH
* Stored in shipping container
USB Interface
Standard Based on Universal Serial Bus
Specifications Revision 2.0, Universal
Serial Bus Device Class Definition for
Printing Devices version 1.1;
Universal Serial Bus Mass Storage class
Bulk-Only Transport Revision 1.0
Bit rate 12 Mbps
Data encoding NRZI
Connector USB Series B
Recommended
cable length 6.6 feet (2 meters) or less
Safety Approvals
Safety standards UL 60950, CSA C22.2 No. 60950
EMC FCC part 15 subpart B class B
CSA C108.8 class B
Noise level 45 dB
Loading Paper
Follow the steps here
to load paper in your
Epson Stylus CX.
1. Open the paper
support and
output tray, then
slide out the
extensions.
2. Flip the feeder
guard forward. Then slide the left edge guide to the left.
Paper
support
Output
tray