Epson Stylus CX7400 Series
4 7/07
Copying: 12 W
Low power: 3 W
Sleep mode: 2.5 W
Power-off mode: 0.2 W
Environmental
Temperature
Operation: 50 to 95 °F (10 to 35 °C)
Storage: –4 to 104 °F (–20 to 40 °C)
1 month at 104 °F (40 °C)
Humidity
Operation: 20 to 80% RH
Storage: 5 to 85% RH
(without condensation)
Standards
Safety UL 60950-1
CAN/CSA C22.2 No. 60950-1
EMC FCC part 15 Subpart B class B
CAN/CSA-CEI/IEC CISPR 22
Class B
Interfaces
USB ports One USB 2.0 Hi-Speed (Device Class
for computers); Type B port
One USB 1.1 Full-Speed (for
PictBridge
™
or USB-DIRECT-
PRINT
™
compliant devices)
Loading Paper
You can load up to 120 sheets of plain paper, 80 sheets of
matte, or 20 sheets of photo paper. Load other special papers
one sheet at a time.
1. Open the paper support and flip up the extension. Then
open the output tray and pull out the extensions.
2. Flip the feeder guard up.
3. Press in the tab on the edge guide and slide it left.
4. Insert the paper, glossy or printable side up, against the
right side and beneath the tab.
Always load paper short edge first, even for landscape
printing. Load letterhead or pre-printed paper top edge
first.
Note:
Do not load paper with holes punched in it.
Do not load paper above the arrow on the edge guide.
Check the paper package for any additional loading instructions.
5. Slide the edge guide against the paper, but not too tightly.
To Next Page
Loading...
Need help?
General
