Epson Stylus Office T1110 - 5.2.6 PF Band Adjustment; 5.3 Adjustment without Using Adjustment Program; 5.3.1 PF Belt Tension Adjustment

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 Revision A
Adjustment Adjustment without Using Adjustment Program 141
Confidential
5.2.6 PF band adjustment
The following pattern is printed.
Figure 5-7. PF Band Adjustment Printout Pattern
How to Judge
Examine the printout patterns and enter the value for the pattern with no overlap and
gap between the two rectangles.
Additional information
When overlap and gap are observed in the all patterns, enter the value for the best one,
and print the adjustment pattern again.
5.3 Adjustment without Using Adjustment Program
This section explains the adjustments that do not use the Adjustment Program.
5.3.1 PF Belt Tension Adjustment
When either of the following parts has been removed or replaced, this adjustment must
be performed to reduce load on the PF Motor and to secure paper feed accuracy.
 PF Motor
 PF Roller Shaft
 Printer Mechanism
The PF Tension Measuring Tool is used for this adjustment.
Figure 5-8. PF Tension Measuring Tool
C H E C K
P O I N T
Example for judgement
1
0
-1
OK NGNG
www.printerwhy.net
高速行式打印机 http://www.lineprinter.com.cn/
_______________________________________________________________________________________
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/ 打印机驱动下载 http://www.printerwhy.com/