Epson Stylus Office T1110 - 6.1.3.1 Lubrication of Carriage Shaft

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 Revision A
Maintenance Overview 160
Confidential
6.1.3.1 Lubrication of Carriage Shaft
1. Fit the Carriage Unit onto the Carriage Shaft, and move it to the center of the
Shaft.
2. Using a syringe, lubricate the holes (2 places) at both ends of the Carriage Unit
rear side with grease.
Figure 6-19. Lubricating the Carriage Shaft (1)
3. Hold the Carriage Unit, and while turning the Carriage Shaft clockwise and
counterclockwise, move the Carriage Unit to spread the grease evenly.
Figure 6-20. Lubricating the Carriage Shaft (2)
4. Move the Carriage Unit to the right end of the Carriage Shaft viewing the Unit
from the rear, and lubricate grease with the syringe at the point shown in refer to
Figure 6-21.
Figure 6-21. Lubricating the Carriage Shaft (3)
C A U T I O N
In the following step, do not bring the needle of a syringe into
contact with the Carriage Shaft.
Lubrication Type Lubrication Amount
G-71 140mg ± 10mg x 2 points
Holes
Carriage Shaft
Carriage Unit
Lubrication Type Lubrication Amount
G-71 140mg ± 10mg x 2 points
Lubrication Point
www.printerwhy.net
高速行式打印机 http://www.lineprinter.com.cn/
_______________________________________________________________________________________
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/ 打印机驱动下载 http://www.printerwhy.com/