Epson Stylus Office T1110 - 4.4 Disassembling the Printer Mechanism; 4.4.1 APG Assy

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 Revision A
Disassembly And Assembly Disassembling the Printer Mechanism 78
Confidential
4.4 Disassembling the Printer Mechanism
4.4.1 APG Assy
1. Remove the Upper Housing / Printer Cover. (p.72)
2. Disconnect the APG Motor connector cable from connector CN118 (red) on the
Main Board.
3. Peel off the acetate tape, and remove the APG Motor cable from the ASF Assy.
4. Disconnect the cables from the two APG Sensor connectors.
Figure 4-28. Disconnecting the Cables
5. Remove the three C.B.S. M3 x 6 screws that secure the APG Assy, and remove the
APG Assy from the Main Frame.
Figure 4-29. Removing the APG Assy
Referring to Figure 4-28, correctly route the APG connector cable.
APG Assy
APG Motor
APG Sensor
connectors
CN118
Hook the APG Motor
cable on the two tabs
of the ASF Assy.
Acetate tape
3
1
2
2) C.B.S. M3x6
(8±1 kgf.cm)
www.printerwhy.net
高速行式打印机 http://www.lineprinter.com.cn/
_______________________________________________________________________________________
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/ 打印机驱动下载 http://www.printerwhy.com/