Epson Stylus Office T1110 - Page 76

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 Revision A
Disassembly And Assembly Removing the Boards 76
Confidential
4. Pull out the Board Assy from the Printer.
Figure 4-22. Removing the Board Assy (2)
REMOVING THE MAIN BOARD
1. Remove the Board Assy (Main Board/Power Supply Board). (p.75)
2. Disconnect the Power Board cable from connector CN60 on the Main Board.
3. Remove the four C.B.S. M3 x 6 screws and one C.P. M3 x 4 screw that secure the
Main Board and remove the Main Board from the Board Assy.
Figure 4-25. Removing the Main Board
 Confirm that the FFCs do not cross each other first, then
connect the FFCs and the cables to the Main Board while
paying attention to the edge of the Shield Plate.
 Take care not to place the Board Assy onto the three Ground
Plates.
Figure 4-23. Reinstalling the Board Assy
Board Assy
Grounding Plates
C A U T I O N
When disconnecting the Power Board cable, be sure to unlock
CN60 on the Main Board.
Figure 4-24. Handling the Power Board cable (CN60)
Lock
Unlock
1
2
3
4
CN60
Main Board
2) C.B.S. M3x6
(6±1 kgf.cm)
14) C.P. M3x4
(4±1 kgf.cm)
5
www.printerwhy.net
高速行式打印机 http://www.lineprinter.com.cn/
_______________________________________________________________________________________
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/ 打印机驱动下载 http://www.printerwhy.com/