Epson Stylus Office T1110 - Page 83

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 Revision A
Disassembly And Assembly Disassembling the Printer Mechanism 83
Confidential
8. Disconnect all the FFCs connected on the CR Relay Board.
 CN1: Printhead
 CN2: Printhead
 CN3: Main Board
 CN4: Main Board
Figure 4-42. Removing the CSIC Assy (2)
9. Remove the C.B.S. M3 x 6 screw that secure the CR Relay Board, and remove the
CR Relay Board from the Carriage Unit.
Figure 4-43. Removing the CSIC Assy (3)
10. Release the two hooks; located on both the left side and the right side of the CSIC
Assy, and remove the CSIC Assy upward.
Figure 4-44. Removing the CSIC Assy (4)
CN3
CN1
CN2
CN4
CR Relay Board
2) C.B.S. M3x6
(6±1 kgf.cm)
Hook
Hook
CSIC Assy
Hook Hook
CSIC Assy
www.printerwhy.net
高速行式打印机 http://www.lineprinter.com.cn/
_______________________________________________________________________________________
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/ 打印机驱动下载 http://www.printerwhy.com/