Epson Stylus Office T1110 - Page 85

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 Revision A
Disassembly And Assembly Disassembling the Printer Mechanism 85
Confidential
 The Printhead must be installed with its positioning holes
aligned with the guide pins of the Carriage Unit.
Figure 4-49. Reinstalling the Printhead (1)
 Route the CSIC FFC through the groove of the Carriage Unit.
Figure 4-50. Reinstalling the CSIC FFC
Guide pins
Positioning holes
CSIC FFC
Groove
 Tighten the screws in the order shown in Figure 4-46
A D J U S T M E N T
R E Q U I R E D
After replacing or removing the Printhead, always make the required
adjustments referring to the following.
• “Chapter 5 Adjustment (p.128)”
www.printerwhy.net
高速行式打印机 http://www.lineprinter.com.cn/
_______________________________________________________________________________________
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/ 打印机驱动下载 http://www.printerwhy.com/