WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 Revision A
Disassembly And Assembly Disassembling the Printer Mechanism 87
Confidential
5. Lift the Printer Mechanism grasping it by the holding positions with your hands,
and remove it from the Lower Housing.
When performing the following step, make sure to grasp the Printer
Mechanism by the specified positions shown below. Otherwise, the
frames may become deformed.
Figure 4-52. Handling the Printer Mechanism
Install the Printer Mechanism to the Lower Housing as follows.
(refer to Figure 4-51)
1. Align the two guide pins with the positioning holes as shown
below.
Figure 4-53. Reinstalling the Printer Mechanism
Right Rear
Left Rear
Positioning hole
and guide pin
Positioning hole
and guide pin
2. Place the
Printer Mechanism
on the Lower Housing and
secure the Shield Plate Holder and the Printer Mechanism
with the screw (A).
3. Verify the Printer Mechanism and Lower Housing are
tightly engaged (no rattling), and then secure the Shield Plate
Holder to the Lower Housing.
4. Secure the Printer Mechanism and Lower Housing with
screws (x5). (Tighten the screws in the order shown in Figure
4-51)
5. Secure the electrode cable to the Front Paper Guide with the
screw.
Route the Ink Tube and the Waste Ink Tube through the three
grooves of the Lower Housing.
Figure 4-54. Reinstalling the Waste Ink Tube
Groove
Waste Ink Tube
Ink Tube
高速行式打印机 http://www.lineprinter.com.cn/
_______________________________________________________________________________________
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/ 打印机驱动下载 http://www.printerwhy.com/
To Next Page
Loading...
