Epson Stylus Office T1110 - Page 94

WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100 Revision A
Disassembly And Assembly Disassembling the Printer Mechanism 94
Confidential
21. Insert the flathead screwdriver and such to the two holes of the Carriage Unit, and
release the two tabs of the Ink Guide from the two hooks of the Carriage Unit, and
then remove the Ink Guide upward.
Figure 4-77. Removing the Ink Guide
 Set the longer end of the Carriage Shaft to the left side.
 When the Carriage Shaft is removed, the Plain spring and Leaf
spring that are attached to the right end of the Carriage Shaft
may drop off. In such case, be sure to attach them in the order
as shown in the figure below.
Figure 4-76. Reinstalling the Carriage Shaft
Leaf spring
Plain spring
Carriage Shaft
Left Side Right
Side
Longer
Shorter
Holes
Bottom Side
Ink Guide
Hook
Ink Guide
Cross-section
Tab
www.printerwhy.net
高速行式打印机 http://www.lineprinter.com.cn/
_______________________________________________________________________________________
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/ 打印机驱动下载 http://www.printerwhy.com/