EPSON Stylus PHOTO 810/820 Revision A
Troubleshooting Troubleshooting with LED Error Indications and Status Monitor 3 Message 53
3.2 Troubleshooting with LED Error Indications
and Status Monitor 3 Message
This section describes the LED indication, the STM3 message and the error detection
condition when the printer detects an error condition in
each sequence/operation (such as
the power on sequence, the paper loading/feeding sequence, the ink absorption sequence,
Table 3-3. Error indication and status monitor 3
Printer status
Indicators
Status monitor 3 message Condition for error detection
Power Error
Fatal error Off On
This error is detected when ;
1) the CR unit cannot move correctly by the
external force in each sequence/operation
2) the PF motor cannot rotate correctly while
the PF motor operates.
Maintenance request Alt Blink Alt Blink
This error is detected when the protection
counter A stored into EEPROM reaches the
limit (32915 points).
To Next Page
Loading...
