R4C706Setup Guide
Rev_D
A5 size SETUP.FM
5/24/01
L
Proof Sign-off:
T.Kubota CRE Nakano
N.Nomoto
editorname
Plugging in the Printer
Follow the steps below to plug in your printer.
1. Make sure that the printer is turned off. It is off when the
P power
button protrudes slightly from the surface of the control panel.
2. Check the label on the back of the printer to make sure the voltage
required by the printer matches that of the electrical outlet you will
be plugging it into. Also, make sure that you have the correct power
cable for your power source.
c
Caution:
It is not possible to change the printer’s voltage. If the rated voltage
and your outlet voltage do not match, contact your dealer for
assistance. Do not plug in the power cord.
3. If the power cord is not attached to the printer, connect it to the AC
inlet at the back of the printer.
4. Plug the power cord into a properly grounded electrical outlet.
Installing Ink Cartridges
This printer uses ink cartridges equipped with IC chips. The IC chip
accurately monitors the amount of ink used by each cartridge, so even
if a cartridge is removed and then inserted again, all of its ink can be
used. However, some ink from both color and black ink cartridges is
consumed each time a cartridge is inserted because the printer
automatically checks reliability.
Be sure to use the ink cartridges packed with your printer the first time
that you install ink cartridges.
Installing the Ink Cartridges
Before installing the ink cartridges, note the following:
w
Warning:
The ink cartridges are self-contained units. Under ordinary use, ink will
not leak from a cartridge. If ink does get on your hands, however, wash
them thoroughly with soap and water. If ink gets into your eyes, flush
them immediately with water.
To Next Page
Loading...
