R4C706Setup Guide
Rev_D
A5 size SETUP.FM
5/24/01
R
Proof Sign-off:
T.Kubota CRE Nakano
N.Nomoto
editorname
Checking the printer
Before printing your first page, you need to make sure that the printer
is working correctly by loading paper, then printing a nozzle check page
and, if necessary, cleaning the print head. Refer to the appropriate
section below.
Loading paper
Follow the steps below to load plain paper into the printer.
1. Lower the output tray and slide out the extension. Slide the left edge
guide so that the distance between the edge guides is slightly wider
than your paper.
2. Fan a stack of paper, then tap it on a flat surface to even the edges.
3. Load the stack of paper into the sheet feeder
with the printable side up and the right edge
of the paper flush against the right edge
guide. Slide the left edge guide against the
left edge of the paper.
Note:
❏ Always load paper into the sheet feeder short
edge first.
❏ Make sure that the paper stack fits under the arrow mark inside the
edge guide.
Checking the print head nozzles
Make sure that the printer is turned
off. Hold down the
b
maintenance
button (➀ in the illustration) and
press the
P power button (➁ in the
illustration) to turn on the printer.
Release only the power button, and
when the printer starts the nozzle
check, release the
b
maintenance
button.
To Next Page
Loading...
