1. Turn off the printer.
2. Hold down the load/eject button and press the
power button. Hold down the buttons until the power
light starts to flash. Then release the buttons.
A page prints out showing the ROM version and a nozzle
check pattern.
3. When it’s finished, turn off the printer. If you have any
problems with the test, see Chapter 6 in your User’s Guide
for more information.
You can connect your EPSON Stylus
™
Photo to either an IBM
®
compatible PC or an Apple
®
Macintosh
®
. You’ll need a shielded,
twisted-pair parallel cable to connect to a PC or an Apple
System Peripheral-8 cable to connect to a Macintosh. For a
complete list of system requirements, see the Introduction of
your printer User’s Guide.
1. Turn off the printer and your computer.
2. Connect the cable to the printer’s parallel interface; then
squeeze the wire clips together until they lock in place. (If
your cable has a ground wire, connect it now.)
3. Connect the other end of the cable to your computer’s
parallel port and secure it as necessary.
Check the Printer
Note:
The printer is assigned to
parallel port LPT1; if you
want to use a different
port, see your Windows
documentation for
instructions.
Connect the Printer to Your Computer
○○○○○○○○○
ground
wire
Connecting to a PC
Quick setup Comoro 5/22/97, 10:18 AM6
To Next Page
Loading...
