Epson Stylus Photo R280 - Page 40

Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50 Revision C
Chapter 3 Troubleshooting 3.3 Troubleshooting by Error Message 40
Confidential
Table 3-9. Troubleshooting for No Paper Error
Occurrence
Timing
Symptom Failed Part Check Point Remedy Reference
Any time
The LD Roller rotates normally to
feed paper, but the Hopper does not
move.
ASF Unit
1. Is the Hopper not moving properly during the
feeding operation?
1. Attach the Compression Spring 2.51
correctly to the ASF Frame and the
Hopper.
4.4.14 “ASF
Unit”(p.92)
The LD Roller rotates normally, but
paper is not fed into the printer.
ASF Unit
1. Is there any paper dust on the LD Roller? 1. Remove the paper dust on the LD Roller
with a cloth moistened with alcohol.
* If this does not solve the problem,
replace the ASF Unit.
The PF Motor drive force is not
transmitted to the LD Roller shaft.
ASF Unit
1. Is the Extension Spring 0.143 of the clutch
mechanism detached?
1. Attach the Extension Spring 0.143
correctly.
2. Is the protrusion of the clutch chipped or broken? 2. Replace the ASF Unit.
ASF
Extension Spring
LD Roller
Protrusion
LD Roller