Epson Stylus Photo R280 - Page 69

Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50 Revision C
Chapter 4 Disassembly/Assembly 4.3.2 Panel Assy/ Cover Open Sensor (Removing Control Boards) 69
Confidential
 Panel Board / Buttons Removal
1. Remove the Panel Assy. (p.67)
2. Remove the screw of the Panel Unit.
• Screw : C.B.P. M3x10 (tightening torque: 3-5 kgf.cm) (No.4)
3. Slide the Panel Unit in the upper right direction and remove it.
Figure 4-28. Removing the Panel Board / Buttons (1)
4. Disconnect the connector (CN1) on the Panel Board, peel the Panel FFC off
the back of the Panel Shield Plate, and remove the Panel FFC.
5. Remove the two screws and remove the Panel Shield Plate from the Panel
Unit.
• Screw : C.B.P. M3x10 (tightening torque: 3-5 kgf.cm) (No.4)
Figure 4-29. Removing the Panel Board / Buttons (2)
6. Disengage the hook on the back of the Panel Board and remove the Panel
Board.
Figure 4-30. Removing the Panel Board / Buttons (3)
7. Release the liens from the guide pins of the Housing Panel B and remove the
sense from the Housing Panel B.
8. Disengage the nine hooks and remove the PS button, Ink button and Paper
button.
Figure 4-31. Removing the Panel Board / Buttons (4)
[Rear Side]
Hook of the Panel
Shield Plate
Groove
Panel Unit
Open Sensor Holder
[Rear side]
Panel Shield Plate
Double-sided Tape
Reference Line
CN1
Panel FFC
Panel Unit
Panel Board
Hook
Positioning Hole
and Guide Pin
[Back Side]
Housing Panel B
Hook
[Back Side]
Guide Pins
Housing Panel B
Paper Button
Ink Button
PS Button
Lens