Epson Stylus Photo R290 - 4.4.2 Printhead

Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50 Revision C
Chapter 4 Disassembly/Assembly 4.4.2 Printhead (Disassembling the Printer Mechanism) 75
Confidential
4.4.2 Printhead
 Parts/Components need to be removed in advance
Printer Cover / Paper Support Assy / Upper Housing
 Removal procedure
1. Move the CR Unit to the center, open the Cartridge Cover and remove all Ink
Cartridges.
2. While disengaging the hook of the Head FFC Cover with a flathead
screwdriver, slide the Head FFC Cover downward and remove it.
Figure 4-45. Removing the Head FFC Cover
3. Disconnect the CSIC FFC from the connector ( ) on the CSIC Board.
Figure 4-46. Removing the CSIC FFC
4. While disengaging the hook of the Head FFC Cover Inner with a flathead
screwdriver, slide the Head FFC Cover Inner upward and remove it.
Figure 4-47. Removing the Head FFC Cover Inner
C A U T I O N
 When removing the Head FFC Cover and the Head FFC
Cover Inner, do not use tools with sharp ends as the FFC may
get damaged.
 Be careful not to damage the FFC and cables when
disengaging the hook of the CSIC Assy.
C H E C K
P O I N T
See the section given below on how to unlock the carriage.
• “4.1.8 How to Unlock the Carriage”
Head FFC Cover
Hook
Removal Direction
Screwdriver
CSIC FFC
Removal Direction
Screwdriver
Hook
Head FFC Cover Inner