Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50 Revision C
Chapter 4 Disassembly/Assembly 4.2.3 Stacker Assy / Stacker Cover (Removing Exterior Parts/Components) 62
Confidential
4.2.3 Stacker Assy / Stacker Cover
Parts/Components need to be removed in advance: Nothing
Removal procedure
1. Open the Stacker Cover.
2. Remove the Stacker Assy.
3. Release the Stacker Cover from the two shafts and remove the Stacker Cover.
Figure 4-12. Removing the Stacker Assy / Stacker Cover
4.2.4 Upper Housing
Parts/Components need to be removed in advance
Printer Cover / Paper Support Assy
Removal procedure
1. Remove the four screws and remove the Upper Housing upward.
•
Screw : C.B.P. M3x10 (tightening torque: 5-7 kgf.cm)
(No.4)
(The numbers shown in the figure indicate the order of tightening the screws.)
Figure 4-14. Removing the Upper Housing
When installing the Stacker Assy, insert the guide pins of the
Stacker Assy into the lower grooves of the Guide Stacker Assy.
(The upper grooves are used when CDR is printed.)
Figure 4-13. Installing the Stacker Assy
To Next Page
Loading...
