Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50 Revision C
Chapter 4 Disassembly/Assembly 4.5.1 Panel Assy (Disassembly/reassembly procedures of Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50) 99
Confidential
4.5  
Disassembly/reassembly procedures of Epson 
Artisan 50/Epson Stylus Photo T50/T59/T60/P50
4.5.1  Panel Assy
 Parts/Components need to be removed in advance
Printer Cover / Paper Support Assy / Housing Upper
 Removal procedure
 Panel Assy removal
1. Disconnect the Panel FFC from the connector (CN5) on the Main Board and 
peel the Panel FFC off the Cable Holder Frame.
2. Disconnect the CDR Sensor Cable and Cover Open Sensor Cable from the 
connectors (CN4, CN17) on the Main Board.
3. Release the CDR Sensor Cable and Cover Open Sensor Cable from the two 
hooks of the Cable Holder Frame.
4. Peel off the acetate tape A, B to separate the CDR Sensor Cable from the 
Cover Open Sensor Cable.
Figure 4-115.  Removing the Panel Assy (1)
5. Remove the two screws.
• Screw  (3 pcs.): C.B.P. M3x6 (tightening torque: 5-7 kgf.cm) (No.1)
• Screw  (3 pcs.): C.B.P. M3x10 (tightening torque: 5-7 kgf.cm) (No.4)
6. From the bottom of the Printer, insert a flathead screwdriver into the hole to 
disengage the tab, and remove the Panel Assy.
Figure 4-116.  Removing the Panel Assy (2)
The disassembly/reassembly procedures for Epson Stylus Photo 
R280/R285/R290 differ from those of Epson Artisan 50/Epson 
Stylus Photo T50/T59/T60/P50, see “4.3.2 Panel Assy/ Cover Open 
Sensor” ( p.67) for the procedures.