Epson Stylus Photo R3000 Series - Loading Thick Media

14 Loading Paper
Loading Thick Media
Use the manual feed tray to load 13 × 19-inch media that is 0.7 to 1.3 mm thick.
Note:
Be sure to leave at least 13 inches (32 cm) of space behind the printer for the media to
feed through.
1. Turn on the printer.
2. Remove any roll paper or paper loaded in the sheet feeder. Close the rear
support if it’s open.
3. Open the front cover, then push the center of the manual feed tray to extend
it.