Handling Paper 7
English
Loading Paper
Into the rear feeder
1. Open and extend the paper support.
2. Move the feeder guard towards you, and
then slide the edge guide.
3. Load the paper short edge first, even for
landscape printing, with the printable
side up.
4. Slide the paper to the right.
5. Slide the edge guide to the right. Make
sure the paper fits under the c arrow
mark inside the left edge guide. Set the
feeder guard back.
Follow the same steps to load A4 paper.
6. Open and extend the output tray.
c Caution:
Make sure the CD/DVD guide is not ejected
before you start printing.
Note:
Make sure the Paper Feed setting is set to Rear
before you start printing.
The printable side
is often whiter or
brighter than the
other side.
10 × 15 cm (4 × 6 in.) and
13 × 18 cm (5 × 7 in.)
A4
To Next Page
Loading...
