Epson Stylus Pro 10000 - Installing Printer Files; Installing Fonts

22 | Quick Installation Guide
After installing the software, you must enable TCP/IP (see page 26).
Before you start, make sure the server has been set up as described on page 5
and is ready.
Installing Printer Files
To set up the Fiery Spark as a PostScript printer, install the Adobe PostScript
printer driver and PPD file that corresponds to your printer.
1. On the User Software CD-ROM, open the
English > Printer Driver
folder.
2. Double-click the
AdobePS 8.7.2 Installer icon.
3. Click
Yes to continue with the installation and to confirm that your
computer must be restarted after installation. The AdobePS Installer
installs the Adobe PostScript printer driver and the PPD file that
corresponds to your printer.
4. Click
Restart when installation is complete.
Installing Fonts
The Fonts installer on the User Software CD-ROM includes screen and
printer fonts that correspond to the 136 built-in PostScript printer fonts
on the Fiery Spark. The Font installer copies both kinds of fonts to the
System Folder > Fonts folder on your hard drive. To be available to
applications, the screen fonts must remain in this folder. The printer fonts can
be copied to a folder of your choice. If you have any applications open, you
must quit and relaunch them before the newly installed screen fonts are
available.
1. On the User Software CD-ROM, double-click the
Fonts icon.
2. At the next screen, click
Install.
3. Click
Restart when installation is complete.