Epson Stylus Pro 10000 - Windows Client Computer; Macintosh Client Computer

4 | Quick Installation Guide
Windows Client Computer
• Pentium III 400MHz (Pentium 4 or higher recommended)
• Windows 98, Me, 2000, XP, or Windows NT
®
4.0 with Service Pack 5 or
later
• 512MB RAM
• PostScript
®
printer driver for Windows
• Windows 98 and Me: Adobe PostScript Printer Driver version 4.3.1
• Windows 2000 and XP: Microsoft PostScript Printer Driver for
Windows 2000 or XP (included with the Windows 2000 and XP
operating systems)
• Windows NT: Adobe PostScript Printer Driver version 5.1.2
• For Windows 98 and Me, you also need TCP/IP networking protocol
enabled
• For Windows 2000, Windows XP, and Windows NT 4.0, you also need
TCP/IP or AppleTalk networking protocol enabled
Macintosh Client Computer
• Macintosh G3, G4, iMac,
®
or eMac
™
(G4 recommended)
• System 8.6 through 9.x
• 450MHz or faster processor
• 512MB RAM
• AppleTalk networking protocol enabled
• TCP/IP configured for using FieryWeb Tools, Fiery Spooler, or
ColorWise Pro
®
Tools
Note
If your operating system isn’t listed above, check
http://support.epson.com to see if a driver is available. At the site,
select your product name and follow the on-screen instructions to
download and install the new driver.