18 Setting Up Your System for Network Printing
Configuring the Network Interface
After connecting the printer to the network, you need to configure the network
interface for use on a TCP/IP network. The following items are used to make
network settings on the printer’s control panel (available only when
NETWORK SETUP is set to ENABLE):
Follow these steps to set the IP address, subnet mask, and default gateway
from the control panel:
1. Make sure that the printer is turned on, and the LCD displays READY.
2. Press the Menu r button on the printer to enter the printer’s menu system.
3. Press d to highlight NETWORK SETUP, then press r.
4. Press r, then d to highlight SHOW.
5. Press OK. A checkmark (✓) appears next to SHOW to show that it’s
selected.
6. Press l to go back, then press d to highlight IP ADDRESS SETTING.
Item Parameter
NETWORK SETUP HIDE, SHOW
IP ADDRESS SETTING AUTO, PANEL
IP,SM,DG SETTING IP ADDRESS
000.000.000.000 to 255.255.255.255
(default setting is 192.168.192.168)
SUBNET MASK
000.000.000.000 to 255.255.255.255
(default setting is 255.255.255.000)
DEFAULT GATEWAY
000.000.000.000 to 255.255.255.255
(default setting is 255.255.255.255)
WSD ON, OFF
BONJOUR ON, OFF
INIT NETWORK SETTING EXECUTE
To Next Page
Loading...
