EPSON
Stylus Pro GS6000 Revision A
6.2.2
Transportation
When detaching the body section
of
the printer from the Stand, follow the steps below.
I.
Insert
the
two
carrying bars
into
their carrier holes (nvo each)
at
the
bottom
of
the
printer.
2.
Verity that the bars are inserted until the heads
of
the screws touch the carrier
holes. then turn the bars so that there
is
a
sc
rew head
in
both sides
of
the carrier
hole's sides. (This prevents the bars from sliding during the transport.).
Figure
6-2.
Preparation
to
Carry
the Body Section
3. Lift the body section using the carrying bars by six people to remove it from Stand.
Figure
6-3.
Detaching the Body Section
CAUTION
I
•
For
the
transport,
if
950ml
cartridges
were
used,
they
should
be
removed
from
the
printer
and
transported
"flat",
wider
side
down
as
vibrations
could
make
the
weight
of
the
ink
moving
inside
the
pocket
causing
premature
wear
of
the
pocket
lower
side
when
the
cartridge
is
transported
on
its
narrow
side
(insertion
position).
If
this
cannot
be
guaranteed,
the
950ml
used
cartridges
should
not
be
transported
and
discarded
instead,
as a
precaution.
(New
cartridges,
cleaning
cartridges
and
initial
charge
ink
cartridges
can
be
transported
in
any
direction.)
MAINTENANCE
Setting up and Transportation 222
Confidential
To Next Page
Loading...
