EPSON Stylus Pro GS6000 Revision A
6.3 Maintenance
When servicing, check the status
of
the following parts. and carry out cleaning.
or
replacement as necessary.
CLEANER
HEAD
Make sure there is no stuck dry ink
on
it.
If
stuck ink is observed, clean the Cleaner
Head using the Cleaning Stick and the Ink Cleaner.
!fit
does not improve the status
much. replace
it
with a new one.
Check
also the status
of
the ink gully.
If
too much ink
is
piling in the gully and may cause ink to overtlow at the next cleaning, replace the
Assy with a
new
one.
• Cleaning
--7
p226
• Replacement
--7
pl53
Figure 6-4. Around the CLEANER HEAD
PRINT HEAD
Make sure there is no dust, dirt.
or
stuck dry ink around the PRINT HEADs.
If
such
abnormality is observed, carry out cleaning using the Cleaning Stick and the Ink
Cleaner. (This cleaning
is
basically expected to be carried out by the users.
If
the
cleaning turns out to be insufficient when checking, explain to the user the importance
of
performing proper regular cleaning.)
If
the cleaning does not improve the status
much, replace the part with a new one.
• Cleaning
--7
p228
• Replacement
--7
pl-15
Figure 6-5. Around the PRINT HEAD
You
may
use the metaiJic tray (provided with the printer) as a
mirror for more convenience.
MAINTENANCE Maintenance 223
Confidential
To Next Page
Loading...
