Epson Stylus SX415 - Page 106

Epson Stylus NX510/515/SX510W/515W/TX550W/NX415/SX410/415/TX410/419/NX215/SX210/215/TX210/213/219/ME OFFICE 510 Revision A
DISASSEMBLY/ASSEMBLY Removing the Circuit Boards 106
Confidential
 Disassembling the Main Board Unit
1. Remove the Main Board Unit. (p105)
2. Remove the screws (x2) that secure the Wireless LAN Board.
3. Disconnect the Wireless LAN cable from the connector (CN3), and remove
the Wireless LAN Board.
Figure 4-21. Removing the Wireless LAN Board
 When installing the Main Board Unit, insert its hooks (x2)
into the cutouts (x2) of the Left Frame.
Figure 4-20. Installing the Main Board Unit
 When reassembling the Main Board Unit, make sure to align
the positioning holes (x2) to the dowels (x2) of the Left Frame
as shown in
Figure 4-19.
 Tighten the screws in the order given in Figure 4-19.
Main Board Unit
Left Frame
Cutout
Hook
C.B.S. 3x6, F/Zn-3C (8±1kgfcm)
Wireless LAN cable
CN3
Wireless LAN Board