Epson Stylus SX415 - Printhead (SX410 Series)

Epson Stylus NX510/515/SX510W/515W/TX550W/NX415/SX410/415/TX410/419/NX215/SX210/215/TX210/213/219/ME OFFICE 510 Revision A
DISASSEMBLY/ASSEMBLY Differences in Disassembling/Reassembling SX410 series 150
Confidential
9. Remove each switch button from the Panel Cover.
Figure 4-136. Removing the Switch button
4.7.3 Printhead (SX410 series)
 Parts/Components need to be removed in advance
Document Cover/ASF Cover/Scanner Unit/Panel Unit/Upper Housing
 Removal procedure
1. Perform Step 1 to Step 8 of "4.5.1 Printhead (p113)".
2. Remove the Head Cable Inner Cover according to the following procedure.
2-1. Release the rib A (x1) of the Head Cable Inner Cover from the cutout
(x1) of the CR Unit.
2-2. Release the tab (x1) of the Head Cable Inner Cover from the groove
(x1) of the CR Unit.
2-3. Release the rib B of the Head Cable Inner Cover from the cutout of
the CR Unit.
Figure 4-137. Removing the Sub FFC Guide
 When installing the Panel Board, align the positioning holes
of the Panel Board with their positioning pins of the Panel
Housing as shown in
Figure 4-135.
 Tighten the screws in the order given in Figure 4-135.
 When installing the Panel Unit, attach it without any gap with
the Upper Housing. (See
Figure 4-30.)
Power SW button
Stop SW button
Start SW button
OK SW button
Mode SW button
Panel SW button
C H E C K
P O I N T
See the following because the disassembling/reassembling
procedures of the Printhead for NX510/SX210 series differ from
those of
SX410 series.
 NX510 series:
“ 4.5.1 Printhead ” (p113)
 SX210 series:
“ 4.8.3 Printhead (SX210 series) ” (p158)
Head Cable Inner Cover
Cutout
Rib B
Rib A and Cutout
Tab and groove
Step 2-1
Step 2-2
Step 2-3