Epson Stylus NX510/515/SX510W/515W/TX550W/NX415/SX410/415/TX410/419/NX215/SX210/215/TX210/213/219/ME OFFICE 510 Revision A
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 136
Confidential
7
For NX510 series:
• Place the tube with a red line to the rear as shown below, and
route the waste ink tubes (x2) without any twisting.
Figure 4-98. Routing the Waste Ink Tube
• Attach the Tube Stopper to the Waste Ink Tube as shown in
the figure below, and insert them into the Waste Ink Cover.
Figure 4-99. Installing the Waste Ink Tube
• When inserting the Waste Ink Tube into the Waste Ink
Cover, make sure that there is no gap between the Tube
Stopper and Waste Ink Cover.
Waste Ink Tube
Groove
Red line
Groove
Blue line
Align the blue markings of
Waste Ink Tube with the edge
of the hook (the one from the
rear side of the printer) on the
Ink System.
36 ± 1mm
36 ± 1mm
Tube Stopper
Waste Ink Tube
For SX410/SX210 series:
• Route the Waste Ink Tube through the groove of the Base
Frame so that the red line of the Waste Ink Tube faces to the
Ink System Unit side.
Figure 4-100. Routing the Waste Ink Tube
• Attach the Tube Stopper to the Waste Ink Tube as shown in
the figure below, and insert them into the Waste Ink Cover.
Figure 4-101. Installing the Waste Ink Tube
• When inserting the Waste Ink Tube into the Waste Ink
Cover, make sure that there is no gap between the Tube
Stopper and Waste Ink Cover.
Tube Stopper
Waste Ink Tube
3
0
±
1
m
m
To Next Page
Loading...
