Epson SureColor P6000 - Cleaning the Print Head Using the Product Control Panel

161
Cleaning the Print Head Using the Product Control Panel
You can clean the print head using the control panel on your product.
1. Make sure roll or cut sheet paper is loaded in the printer.
2. Make sure the correct paper type is selected.
3. Press the Menu button.
4. Press the up or down arrow button to select Maintenance and press the right arrow button.
5. Select Head Cleaning and press the right arrow button.
6. Select one of the following:
• To clean all nozzles, select All Nozzles and press the right arrow button.
• To select the specific nozzles for cleaning, select them and press the right arrow button.
7. Press the OK button.
8. Select one of the following as the cleaning strength level:
• For a first cleaning, select Normal.
• If nozzles are still clogged after three normal level cleanings, select Power Cleaning.
9. Press the OK button to start the cleaning cycle.
When the cleaning cycle is finished, the power light stops flashing and a confirmation screen
appears.
Caution: Never turn off the product during a cleaning cycle or you may damage it.
10. Select Nozzle Check and press the right arrow button.
11. Press the OK button.
The nozzle pattern prints.
12. Check the printed pattern to see if there are gaps in the lines.
Note: Use at least a 10× eye loupe to examine the pattern for any missing or deflected dots or
segments.